CONNER PERIPHERALS, INC.

C4320RT, C4324RP

Device Type             Internal Tape Drive
Interface               SCSI-2
Format                  DDS, DDS-DC
Sustained Transfer Rate Unidentified
Size                    3.5 in. half height

                        5.25 in. half height (with bezel)
View                    Top


                        USER CONFIGURABLE SETTINGS

                 Setting                     Label          Position

  »   Factory configured - do not alter       JP1         Unidentified

  »   Factory configured - do not alter       JP6         Unidentified

  »   SCSI 2 mode enable                     SW1/4             On

      SCSI 1 mode enabled                    SW1/4            Off

  »   Parity check disabled                  SW1/5            Off

      Parity check enabled                   SW1/5             On

  »   Compression enabled                    SW1/6            Off

      Compression disabled                   SW1/6             On

  »   Factory configured - do not alter      SW1/7        Unidentified

  »   Self-test diagnostics disabled         SW1/8            Off

      Self-test diagnostics enabled          SW1/8             On

  Note: The tape control software provided has the ability to override
  SW1/6, regardless of its position. For model C4320RT, SW1/6 is reserved
  and should be left in the Off position.

                              DRIVE SELECT ID

     Drive ID             SW1/1             SW1/2              SW1/3

  »        0               Off               Off                Off

           1               On                Off                Off

           2               Off                On                Off

           3               On                 On                Off

           4               Off               Off                On

           5               On                Off                On

           6               Off                On                On

           7               On                 On                On

                        TERMINATION POWER SELECTION

                  Setting                                JP4

  »   TERMPWR supplied by drive                          Open

      TERMPWR supplied by SCSI interface                Closed
      to drive

                      MANUFACTURERS RECOMMENDED MEDIA

               Tape                               Capacity

    Conner DAT Data Cassette (60                Unidentified
              merter)

    Conner DAT Data Cassette (90                Unidentified
              merter)


                             DIAGNOSTIC LED(S)

    LED       Color        Status                  Condition

   LED1       Green          On             Drive receiving power and
                                                operation normal

   LED1       Green      Slow Flash       Inserted cassette generating
                                             errors (warning only)

   LED1       Green      Rapid Flash   Drive could not write correctly to
                                                      tape

   LED1       Green          Off                 No drive power

   LED2       Amber          On         Drive reading from or writing to
                                                      tape

   LED2       Amber      Rapid Flash   Condensation detected in drive, or
                                             hardware fault occured

   LED2       Amber          Off                Drive not active

  Note: If LED1 is flashing slowly while LED2 is On, a prerecorded audio
  cassette is loaded and is being played automatically.